Software

Adjust trigger properties such as Trigger Position and Trigger Delay.

Figure 1:Trigger Options dialog box

This function can divide the long signal into pages for capturing and analyzing.

For example: Use the Up Count to capture the signal, and set the memory of each page as 1K, then the waveform will be displayed as below:

Figure 1：Memory is 1K，Page 1，The end time is 185.2us

Figure 2：Memory is 1K，Page 2， The start time is 185.4us，the end time is 388.6us

Figure 3：Memory is 1K，Page 3 ，The start time is 390.4us， the end time is 593.6us

Under the same trigger condition, users can use the trigger page function to capture the whole signal in many times. The data in each page is continuous, that will help users to do long-time analyzing.

Users can set the trigger position in percentage to display the status before trigger happens. See figure 2, the trigger position is set as 90%, that’s mean only 10% of memory is used to store the status after trigger, 90% is for the status before trigger.

Figure 1：trigger position is 10％

Figure 2：trigger position is 90%.