Logic Analyzers-Zeroplus
   
 
 
  youtube facebook twitter  
  Instrument Division
繁體中文 / 简体中文 / English  

Software

>> Trigger Function Home / LAP-C-Pro ZP-Logic /
  Software quick application note
Trigger Function
 Signal Process
 Mode function
 Other
- Trigger Setup(quick) / Trigger Count / Trigger Mark -

 

Trigger Setup(quick)

1. Trigger mode

Trigger mode has Waveform trigger and Pattern trigger.

(1) Waveform trigger

In the UI of waveform trigger, clicking the button “Show the waveform area” and box choose waveform need to trigger, the Preview result as Figure 2.

Waveform trigger dialog box

Figure 1:Waveform trigger dialog box

 

Waveform trigger preview dialog box

Figure 2:Waveform trigger preview dialog box

 

Select the triggered wave to trigger the wave in which high and low levels are in tolerance, the levels are shown:

the levels

 

(2) Pattern trigger

In the UI of Pattern trigger, there can set the condition of Interval, Width, Wait for Bus or Signal shown as Figure 4 , Click ”Go To” can start Trigger or Next Pattern shown as Figure 5 .

Pattern trigger dialog box

Figure 3:Pattern trigger dialog box

 

Bus/Signal dialog box

Figure 4:Bus/Signal dialog box

 

Condition dialog box

Figure 5:Condition dialog box

 

2. Edge trigger

Edge trigger have Trigger on channel edge rising, Trigger on channel edge falling, Trigger on channel edge either, and Trigger on channel edge and pattern.

(1) Trigger on channel edge rising

Trigger on channel edge rising dialog box

Figure 6:Trigger on channel edge rising dialog box

 

(2) Trigger on channel edge falling

Trigger on channel edge falling dialog box

Figure 7:Trigger on channel edge falling dialog box

 

(3) Trigger on channel edge either

Trigger on channel edge either dialog box

Figure 8:Trigger on channel edge either dialog box

 

(4) Trigger on channel edge and pattern

Trigger on channel edge and pattern dialog box

Figure 9:Trigger on channel edge and pattern dialog box

 

3. Timer trigger

Time trigger have Hold time trigger and Trigger delay.

(1) Hold time trigger

Hold time trigger dialog box

Figure 10:Hold time trigger dialog box

 

(2) Trigger delay

Trigger delay dialog box

Figure 11:Trigger delay dialog box

 

Trigger Count

Trigger on the Xth event that satisfies the trigger conditions; at the default value of 1 the LAP-C-Pro/2 will trigger on the first event.

Users can set to mark with trigger bar after the trigger condition is met for specified times(1-65535).

Set the trigger count to 1-3, below figures are their results:

Set the trigger count

Figure 1:Set the trigger count to 1, the trigger condition to rising edge of A0. The Logic Analyzer will mark the first rising edge of A0 with trigger bar after it receives the signal.

 

Set the trigger count

Figure 2:Set the trigger count to 2. Compared with the figure 1, the trigger bar is moved to the second rising edge of A0, that means this position is where the trigger condition is met for the second time.

 

Set the trigger count

Figure 3:Set the trigger count to 3. Compared with the figure 1 and 2, the trigger bar is moved to the third rising edge of A0, that means this position is where the trigger condition is met for the third time.

 

Trigger Mark

Place a vertical bar on all samples that meet the trigger conditions. By default, only one trigger bar is shown (the T-bar), but there can be up to 256 trigger bars. These are numbered T0, T1, T2 etc. (Trigger Marks are sometimes referred to as Cursors or Auxiliary Cursors).

 
Copyright ZEROPLUS TECHNOLOGY CO., LTD.