New Functions 1. Report a Problem Before Modification: The Report a Problem function uses the Windows’ built-in Mail Software,Question Report. But the Mail Software is never built in the Windows7 System, which causes that the Report a Problem function can not be operated in the Windows 7 System normally. After Modification: Design a standalone Mail Software, Problem Feedback. 2. Save the Compression Format of the File Before Modification: No Support. After Modification: Add the Compression Algorithm in the process of saving the Software and reduce the Memory Size of the File. 3. AP Sharing Before Modification: Install the Software of each Model independently. After Modification: Merge into a set of Installation Software, which is convenient for the users with multiple Models and saving the space of the Hardware Disk. 4. Show the T Bar in the middle of the Waveform Display Area after triggering. Before Modification: Place the T Bar in the middle of the Waveform Display Area after triggering. After Modification: Add “Show the T Bar in the middle area” option in the Common Setup dialog box of the Customize. After triggering, users decide to place the T Bar in the middle of the Waveform Display Area or keep the current Position of the T Bar in the Waveform Display Area. 5. Add the new Data Format, Decimal (Signed). Before Modification: No Support. After Modification: Support the Decimal (Signed). 6. Support decoding the Special String of the Protocol Analyzer. Before Modification: No Support. After Modification: Support decoding the Special String of the Protocol Analyzer (For example, decimal point). Enhanced Functions 1. Data Statistics Function Before Modification: When the Software is activated every time, the Settings of the Data Statistics are the default. After Modification: The Settings has been saved in the File, so it is unnecessary for the users to reset. 2. Time/Address Display in the Listing Display Window Before Modification: Display the Address only. After Modification: In the Hide time of waveform or the Sampling Site Display mode, the Bus/Signal column displays the Address; in the Frequency Display or the Time Display mode, the Bus/Signal column displays the Time. 3. Function Registration of the Main Program (Trigger Mark, Latch and Data Contrast) Before Modification: Some Models can not support these functions. After Modification: These Models can support these functions through registering. Modified Functions 1. The third and fourth Logic Analyzers for stacking can not capture the data. Before Modification: The third and fourth Logic Analyzers for stacking can not capture the data. After Modification: The third and fourth Logic Analyzers for stacking can capture the data normally. 2. When the RAM Size is set to 32K, the Sampling Frequency is set to 1KHz, the Trigger Position is set to 0% and the Trigger Conditions are not set, if users run the Software, it will be running continuously. Before Modification: The Software can not stop running. After Modification: The Software will capture the data normally and then stop running. 3. The Display Bar will draw the error image in the Width Screen Resolution mode. Before Modification: The Display Bar will draw the error image. After Modification: The Display Bar will draw the right image. 4. Add the Pull-down Options. Before Modification: No Support. After Modification: Add the Signal Filter Setup option on the pull-down menu of the Bus/Signal; add the Navigator, Memory Analyzer, Bus Packet List and Statistics Window options on the pull-down menu of the Window. 5. Merge the Waveform Width Information into one Button. Before Modification: There are four Buttons (Time Display, Sampling Site Display, Frequency Display and Hide time of waveform) on the Toolbars column. After Modification: The four Buttons are merged into one Button, and the Mode can be switched through clicking the Button or selecting an option from the pull-down menu of the Button. 6. Modify the Names and Arrangement of the Buttons (Bus Packet List, Memory Analyzer and Statistics Window) and adjust the Reaction Statuses. Before Modification: No Support. After Modification: Modify the Names and Arrangement of the Buttons (Bus Packet List, Memory Analyzer and Statistics Window) and adjust the Reaction Statuses. 【DOWNLOAD】